%0 Journal Article
%A Latour, Isabel
%A Miranda Carreño, Rubén
%A Blanco Suárez, María Ángeles
%T Silica removal in industrial effluents with high silica content and low hardness
%D 2014
%@ 0944-1344 
%U https://hdl.handle.net/20.500.14352/33920
%X High silica content of paper mill effluents is limiting their regeneration and reuse after membrane treatments such as reverse osmosis (RO). Silica removal during softening processes is a common treatment; however, the effluent from the paper mill studied has a low hardness content which makes necessary the addition of magnesium compounds to increase silica removal. Two soluble magnesium compounds (MgCl2∙6H2O and MgSO4∙7H2O) were tested at five dosages (250-1500 mg/L) and different initial pHs. High removal rates (80-90%) were obtained with both products at the highest pH tested (11.5). With these removal efficiencies, it is possible to work at high RO recoveries (75-85%) without silica scaling. Although pH regulation significantly increased the conductivity of the waters (at pH 11.5 from 2.1 mS/cm to 3.7-4.0 mS/cm), this could be partially solved by using Ca(OH)2 instead of NaOH as pH regulator (final conductivity around 3.0 mS/cm). Maximum chemical oxygen demand (COD) removal obtained with caustic soda was lower than with lime (15% vs. 30%). Additionally, the combined use of a polyaluminum coagulant during the softening process was studied; the coagulant, however, did not significantly improve silica removal, obtaining a maximum increase of only 10%.
%~