%0 Journal Article
%A Del Nero Beneitez, María Olga
%A Macorra García, José Carlos De La
%T Sealing and Dentin Bond Strengths of Adhesive Systems
%D 1999
%@ 0361-7734
%U https://hdl.handle.net/20.500.14352/60380
%X The objectives of this research were (1) to analyze the variations of the permeability of dentin after restoration with two polyacid-modified resin composites (Compoglass, Dyract) and four single-bottle adhesives (Prime & BOnd 2.0, Syntac Single Component, OptiBond Solo, and Single Bond -Scotch Bond 1 in Europe- immediately (approximately 1 hour) after insertion. A perfusion system with distilled water was used at a pressure of 32.5 cm of water; (2) to study the bond strength of their interfaces; and (3) to find the correlation, if any, between both parameters. None of the materials used produces a complete cessation in fluid filtration. Tensile strengths were very low (maximum: P&B=3.96MPa) probably because of the very large bonding surfaces used (mean bonded surface area = 88.8mm²). No significant correlation was found between tensile bond strength and the sealing ability for any material.
%~