2026-06-07T11:29:13Zhttps://docta.ucm.es/rest/oai/request

oai:docta.ucm.es:20.500.14352/603802024-10-29T14:04:07Zcom_20.500.14352_14col_20.500.14352_15

Sealing and Dentin Bond Strengths of Adhesive Systems Del Nero Beneitez, María Olga Macorra García, José Carlos De La The objectives of this research were (1) to analyze the variations of the permeability of dentin after restoration with two polyacid-modified resin composites (Compoglass, Dyract) and four single-bottle adhesives (Prime & BOnd 2.0, Syntac Single Component, OptiBond Solo, and Single Bond -Scotch Bond 1 in Europe- immediately (approximately 1 hour) after insertion. A perfusion system with distilled water was used at a pressure of 32.5 cm of water; (2) to study the bond strength of their interfaces; and (3) to find the correlation, if any, between both parameters. None of the materials used produces a complete cessation in fluid filtration. Tensile strengths were very low (maximum: P&B=3.96MPa) probably because of the very large bonding surfaces used (mean bonded surface area = 88.8mm²). No significant correlation was found between tensile bond strength and the sealing ability for any material. 2023-06-20T20:30:38Z 2023-06-20T20:30:38Z 2023-06-20T20:30:38Z 1999 journal article https://hdl.handle.net/20.500.14352/60380 0361-7734 spa open access