Person: Alda Serrano, Javier
Loading...
First Name
Javier
Last Name
Alda Serrano
Affiliation
Universidad Complutense de Madrid
Faculty / Institute
Óptica y Optometría
Department
Óptica
Area
Optica
Identifiers
5 results
Search Results
Now showing 1 - 5 of 5
Item Application of tomographic techniques to the spatial-response mapping of antenna-coupled detectors in the visible(Applied Optics, 2008) Rico García, José María; Sánchez Brea, Luis Miguel; Alda Serrano, JavierA tomographiclike method based on the inverse radon transform is used to retrieve the irradiance map of a focused laser beam. The results obtained from multiple knife-edge measurements have been processed through a kriging technique. This technique allows us to map both the beam irradiance and the uncertainty associated with the measurement method. The results are compared with those achieved in the standard fitting of two orthogonal knife-edge profiles to a modeled beam. The application of the tomographiclike technique does not require any beam model and produces a higher signal-to-noise ratio than the conventional method. As a consequence, the quality of the estimation of the spatial response map of an antenna-coupled detector in the visible is improved.Item Estimation of the influence of finite dielectric substrates on the far-field pattern of an array of metallic scatterers in the infrared(Infrared Physics & Technology, 2005) Rico García, José María; López Alonso, José Manuel; Alda Serrano, JavierThe far-field scattered in the infrared by an arrangement of metallic structures deposited on a dielectric wafer is estimated in this paper. The scattering is modelled by using operators that describe the far field obtained under the regime applicable for the Babinet's principle in its vectorial approach and the Stratton–Chu approximation. The far-field scattered by an arrangement of thin gold layers over a dielectric wafer under infrared illumination is computed. The model assumes a normally incident vectorial Gaussian beam focused over the arrangement plane. An angular spectrum decomposition of the field is done. Then, every plane wave is scattered by the whole structure: arrangement + substrate layer. The reflexions in the substrate layer and the arrangement action have been taken into account in an operator formalism. Numerical results estimating the influence of substrate thickness on the pattern are obtained.Item Finite-difference time-domain simulation of low-F# Fresnel zone plates coupled to IR antennas(Proceedings of SPIE, 2004) Rico García, José María; López Alonso, José Manuel; Lail, Brian; Boreman, Glenn; Alda Serrano, JavierFresnel Zone Plate Lenses (FZPLs) have been successfully coupled to infrared (IR) antennas producing a responsivity enhancement of about two orders of magnitude. However, their lateral extension may compromise their applicability in focal-plane-arrays (FPA) IR imagers, where the dimensions of the pixel are constrained by the FPA spacing. When designing optimum-gain FZPLs for FPAs, we are lead to the requirement of FZPLs operating at very low F/#s (marginal rays propagating at a large angle in image space). In this case, Finite-Difference Time-Domain techniques (FDTD) are used to refine the physical-optics modelling results, producing a result closer to the actual case encountered in a high-fill-factor FPA. In this contribution, we analyze the FZPL designs by using FDTD techniques. The main result of the FDTD computation is the gain factor defined as the ratio of the response of the IR antennas coupled with the FZPL, compared to the same antennas without the FZPL.Item High-resolution spatial-response measurements of optical nano-antennas in the visible(IEEE Antennas and Propagation Society International Symposium, IEEE Antennas and Propagation Society International Symposium, 2007) Alda Serrano, Javier; Rico García, José María; López Alonso, José Manuel; Boreman, GlennA few years ago, some of the authors of the paper demonstrated the resonance of optical antennas in the visible frequencies. The results of that paper were obtained using experimental techniques that were primarily developed for the measurement of antenna-coupled detectors in the infrared. In the present paper, we show the results of spatial-response mapping obtained by using a dedicated measurement station for the characterization of optical antennas in the visible. At the same time, the bottleneck in the spatial responsivity calculation represented by the beam characterization has been approached from a different perspective. The proposed technique uses a collection of knife edge measurements in order to avoid the use of any model of the laser beam irradiance. By taking all this into account we present the spatial responsivity of optical antennas measured with high spatial resolution in the visible.Item Optical antennas for nano-photonic applications(Nanotechnology, 2005) Alda Serrano, Javier; Rico García, José María; López Alonso, José Manuel; Boreman, GlennAntenna-coupled optical detectors, also named optical antennas, are being developed and proposed as alternative detection devices for the millimetre, infrared, and visible spectra. Optical and infrared antennas represent a class of optical components that couple electromagnetic radiation in the visible and infrared wavelengths in the same way as radioelectric antennas do at the corresponding wavelengths. The size of optical antennas is in the range of the detected wavelength and they involve fabrication techniques with nanoscale spatial resolution. Optical antennas have already proved and potential advantages in the detection of light showing polarization dependence, tuneability, and rapid time response. They also can be considered as point detectors and directionally sensitive elements. So far, these detectors have been thoroughly tested in the mid-infrared with some positive results in the visible. The measurement and characterization of optical antennas requires the use of an experimental set-up with nanometric resolution. On the other hand, a computation simulation of the interaction between the material structures and the incoming electromagnetic radiation is needed to explore alternative designs of practical devices.